EUI/ EUP Tester testing Unit Pump

2 Operating Instructions

2.1 Keyboard Layout

2.2 Basic Operation

1、After the power is turned on, the startup screen is shown below

Press the corresponding function key, then press the number keys or the arrow keys to set the corresponding parameters.
Left and right arrows to move the cursor, and the up and down arrows to change the value. After setting, press Enter to confirm.

F1: angle setting;
F2: Set the number of counts 0～9999;
F3: Chinese / English switching;
F5: Start;
F4: EUI/EUP type switching;
F6: Stop;
F7: start counting;
F8: Stop counting;
F9: Save the current settings.

F0: Go to the Settings page, set the page as follows

F0: switch between four preset EUI/EUP;
F1: driving voltage switching;
F2: enhance the pulse width setting 0～900us;
F3: total width setting 0～8000us;
F4: enhance the current setting 0～30A;
F5: keep the current setting 0～20A;
F6: drive mode, auto / fixed pattern;
F7: Minimum pulse width;
F8: Maximum pulse width;
F9: 0 to 50% duty cycle

3 Start Test

a、installed the EUI/EUP；
b、corresponding to the rotational speed of the motor；
c、set angle
d、 Press F5 to start, press UP/DOWN to change pulse width, press 100US for long and 10US for short;
e、press F5 to start, after the fuel injection quantity is stable, press F7 starting amount of oil.
f、Press the up and down arrows to change the advance angle.